Solve
Guides
0
Question
In JK flip-flop, same input, i.e. at a particular time or during a clock pulse, the output will oscillate back and forth between 0 and 1. At the end of the clock pulse the value of output Q is uncertain. The situation is referred to as -
- Conservation condition
- Race around condition
- Lock out state
- None of these
Open in App
Solution
Verified by Toppr
In JK flip-flop, same input that is at a particular time or during a clock pulse, the output will oscillate back and forth between 0 and 1. At the end of the clock pulse the value of output Q is uncertain. The situation is referred to as race around condition.
A race condition is an undesirable situation that occurs when a device or system attempts to perform two or more operations at the same time, but because of the nature of the device or system, the operations must be done in the proper sequence to be done correctly.
Was this answer helpful?
0
Similar Questions
View Solution
View Solution
Q3
Consider the following logic diagram :
After applying 4 clock pulses, which input sequence(s) for ABC will always generate logic 1 at the output Z. (Assume initially all flip-flops are cleared)
After applying 4 clock pulses, which input sequence(s) for ABC will always generate logic 1 at the output Z. (Assume initially all flip-flops are cleared)
View Solution
Q4
The digital circuit shown in figure generates a modified clock pulse at the output. Choose the correct output waveform.
View Solution
Q5
The correct cyclic sequence of the outputs (Q0,Q1) for the JK master-slave flip-flop circuit shown in figure when the input clock applied is
View Solution